OKX Wallet Sign up

* Motorcycle engine braking skills Motorcycle braking has always been a key topic for riders. Under normal circumstances,OKX Wallet Sign up we use the front and rear brakes to slow down or stop, but it is not always reliable when braking urgently. At this time, using a motorcycle engine to brake is a very practical skill. Motorcycle engine braking can not only increase the stability and safety of the brakes, but also avoid the long-term use of the brake mechanism and extend the service life of the brake pads. In this article, I will share with you how to use motorcycle engines to brake. Step 1: Predict the road conditions. Before using the motorcycle engine to brake, we need to pay attention to the road conditions and the surrounding environment. We need to fully estimate the traffic and road conditions ahead, as well as the upcoming road sections in the future.If the road ahead is busy, the cliff is steep or requires emergency braking, you can ignore this technique. In general, it is very safe and effective to use the engine for braking. Step 2: Lower the gear. Now, most motorcycles are already equipped with transmissions and clutches. We can reduce the gear to reduce the speed and make effective use of the engine's restraint. Lowering the gear is the most reliable way to reduce the engine speed when slowing down. However, we should not slow down too fast, otherwise the engine may turn off when the speed is too low. Step 3: Using the clutch, we can adjust the state of the clutch to control the power of the engine when decelerating. When you lower the gear and switch to a new gear, you should release the clutch so that you can effectively use the power of the engine. However, in order to reduce the wear of the clutch during braking, please always pay attention to the condition of the clutch and how to use it.Step 4: Lean forward. After starting to slow down, we should tilt the center of gravity forward, which can effectively increase the friction between the tires and the road surface. This makes the motorcycle more stable, especially during the deceleration process. Step 5: Maintaining balance and maintaining good contact with the ground is the key to maintaining balance. When using motorcycle engine brakes, especially at slow speeds, we should be extra careful. If you hold it too hard, you may cause a slight shake, which will make you lose your balance. On the contrary, loosen it properly and reduce the pressure on the handle, which can help you better control the balance of the body. Step 6: Use normal brakes. Under normal circumstances, we should use front and rear brakes and engine brakes at the same time. In the case of emergency braking, engine braking should be used as little as possible. If the situation permits, you can step on the brake firmly to achieve a more stable braking effect.In a word, special attention should be paid to the balance between skill and braking force, and targeted preparation should be made before use. In a word, motorcycle engine braking skills are a very practical technology. Using the engine to assist in deceleration can help you control your motorcycle more efficiently and reliably. Of course, this skill still needs to be used and mastered correctly. Before using this technique, please make sure that you have fully mastered the operating steps and precautions to ensure the safety of you and your passengers.

Contact Us
Phone：020-83484628